Load the external encoder configured under Encoder Workcell Item.
Triggering Mute Time is used when the noise in the triggering switch sensor is at an acceptable level. For example, when a workpiece passes through the triggering switch, an edge may be detected, but additional samples of the edge may be detected within a short period of time after detection due to the electric noise generated during signal switching. In such cases, set the mute time to allow the first edge detected to be recognized as a workpiece and subsequent edge detections after the first detection to be ignored for the set time. This setting is used when the workpiece interval can be estimated and electrical noise cannot be controlled due to poor conditions in the work environment.
