Welding process parameters are the parameters determining the signal order (i.e., start/end (crater) current condition, gas discharge of welding) and time.
-
Welding Process Parameter Settings
|
No. |
Item |
Description |
|---|---|---|
|
1 |
Start/End Feeding Speed Value (in %) |
This sets the ratio between the start feeding speed and end feeding speed based on the target feeding speed (100%). |
|
2 |
Start/End Voltage Value (in %) |
This sets the ratio between the start voltage and end voltage based on the target voltage (100%). |
|
3 |
Protective Gas Discharge Start/End Time (in seconds) |
This sets the protective gas discharge time before welding start wire feeding/after welding end wire feeding. (can be set between 0-10) |
|
4 |
Start/End Period (in seconds) |
This sets the start and end condition times. (can be set between 0-10) |
|
5 |
Change Welding Condition Time (in seconds) |
Enter the changed time to smoothly shift from the current target to the next target when the welding condition target changes. (can be set between 0-10) |