struct.CONFIG_DIGITAL_WELDING_CONDITION

This structure contains information for configuring digital welding conditions.

• The _cVirtualWelding member variable sets the virtual welding mode. 0 means actual welding, 1 means virtual welding.

• The _fTargetVel member variable sets the target speed.

• The _fMinVelLimit and _fMaxVelLimit member variables set the minimum speed limit and maximum speed limit, respectively.

• The _nWeldingMode, _n2t2tSpecial, _nPulseMode, and _nWMopt1 member variables set the welding mode, 2T2T special mode, pulse mode, and WM option 1, respectively.

• The _cSimulation member variable sets the simulation mode. 0 means disabled, 1 means enabled.

• The _cTSopt1 and _cTSopt2 member variables set TS option 1 and TS option 2, respectively.

• The _nJobNumber and _nSynergicID member variables set the job number and synergic ID, respectively.

• The _fWireFeedSpeed, _fArclengthCorrection, and _fDynamicCorrection member variables set the wire feed speed, arc length correction, and dynamic correction, respectively.

• The member variables from _fOption1 to _fOption15 set additional options.