struct.CONFIG_DIGITAL_WELDING_IF_MAPPING_DATA

This structure is used to configure mapping data for the digital welding interface.

The _bEnable member variable indicates whether the mapping data is enabled. 0 means disabled, 1 means enabled.
The _nDataType member variable specifies the data type. 0 means On/Off signal, 1 means value.
The _nPositionalNumber member variable specifies the positional number of the data. 0 means 1, 1 means 0.1, 2 means 0.001.
The _fMinData and _fMaxData member variables represent the minimum and maximum data values, respectively.
The _nByteOffset and _nBitOffset member variables represent the byte offset and bit offset, respectively.
The _nComnDataType member variable specifies the communication data type.
The _nMaxDigitSize member variable represents the maximum digital value.

BYTE#	Member Variable	Data Type	Value	Description
0	`_bEnable`	unsigned char	0 or 1	Enabled status (0: Disabled, 1: Enabled)
1	`_nDataType`	unsigned char	0 or 1	Data type (0: On/Off, 1: Value)
2	`_nPositionalNumber`	unsigned char	0, 1, or 2	Positional number (0: 1, 1: 0.1, 2: 0.001)
3	`_fMinData`	float		Minimum data
7	`_fMaxData`	float		Maximum data
11	`_nByteOffset`	unsigned char		Byte offset
12	`_nBitOffset`	unsigned char		Bit offset
13	`_nComnDataType`	unsigned char	0 ~ 7	Communication data type (0: 1-bit (Disable Low), 1: 1-bit (Disable High), 2: 2-bit, 3: 4-bit, 4: 8-bit, 5: 15-bit, 6: 16-bit, 7: 32-bit)
14	`_nMaxDigitSize`	unsigned char		Maximum digital value